Ram Rebel Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
129 Posts
Discussion Starter #1
I know were still a bit out but Im wondering what you guys have in mind for mods. Anything, or did RAM cover most of the desired bases??
 

·
Registered
Joined
·
22 Posts
Flame Red/black 2 tone, 2016 Dodge Ram Rebel, 4x4, 5.7L Hemi, 3.92 gears, 8spd auto trans. Here are some mods I have done so far;* Added extended mopar warranty, Added Mopar Ram 5-1/2" oval black side steps, Added Mopar Ram contoured mud flaps, Added Leer 100 box cap w/lighting, Factory under coating/fabric protection, Installed AVS window deflectors, Added 3 ball trailer hitch with keyed Master locking pin, Changed to Airborne lisence plate holder on the front and back, Added Front plate Airborne crest, Installed Custom lisence plate "KEWL" on the back, Added DeeZee tailgate Assist, Changed .50cal Bullet Black antenna, Added Garmin GPS, Added Garmin Dash Cam, Added Escort Radar Dector, Upgraded 4 Tire Nitrogen fill, Changed to Rainx 27" & 24" winter wipers, Changed Security locking wheel nuts, Changed Mopar CAI cool air system intake, Installed Mopar cold air duct, Swapped Cat back SS Magnaflow exhaust w/5" tips, Installed Mopar back up camera, Added heater to windshield washer tank, Added Mopar SS rocker guards, Added Mopar bug deflector, Added Mopar SS pedal covers, Applied Mopar paint sealer, Installed 5lb. ABC fire extinguisher mounted to inside of tailgate, Added St. John Ambulance first aid kit, Added 2gal plastic garbage bin on floor rear seat, Attached Airborne crest and Ram Rebel.org stickers to the box cap, installed Veteran stickers to box cap, Changed OPT-7 led lights to replace low beams, Installed Altered OffRoad 27" light bar added behind lower grill, Swapped all interior lights with 6000k LED lights, Changed the under hood light to 2 LEDs, Add rear LED 60" light bar w/signal and brake function between bumper and bottom of tailgate, Change lisence plate lights to LED types, Add rear 2x6 LED back up light floods, Added truck bed partition, Added DeeZee bush bar, Black out front end including skid plate and RAM, install Rebel and Flame door stickers, installed tailgate seal, installed Train horn. Installed Fairlead, installed custom mounting plate and Smittybuilt 9500lb winch.
More mods to follow, Install roof clearance lights, Install hood graphics, Add Electric Mopar brake controller.
 

·
Registered
Joined
·
436 Posts
What does the electric brake controller do ? Like.. I'm sure it's pretty straightforward as the name sounds but how does it function ?
 

·
Registered
Joined
·
22 Posts
Electric brake controller

On trailers that are equipped with electrical brakes they can be adjusted to have them activated when you press your brake pedal. You can control how much force that is applied to them using a slider control in the rebel. For trailers get in hilly areas they give better stopping power and Hensley me re control over stopping. It's about a $400 item f ok mopar. The controlled has 2 wiring harnesses to connect inside the dashboard, installation should be done by dealer to maintain the warranty. I'm just saving my buttons to save my 34' 2015 wild wood camper
 

Attachments

·
Registered
Joined
·
22 Posts
Electric brake controller

On trailers that are equipped with electrical brakes they can be adjusted to have them activated when you press your rebel brake pedal. You can control how much force that is applied to them using a slider control in the rebel. For trailers that get in hilly areas, they give better stopping power and, Hensley more control over stopping. It's about a $400 item from mopar. The controlled has 2 wiring harnesses to connect inside the dashboard, installation should be done by dealer to maintain the warranty, and they ref lash the vin code. I'm just saving my $$$buttons to help stop my 34' 2015 wild wood camper.
 

·
Registered
Joined
·
436 Posts
Now that is definitely not what I was thinking it was.

But I can see how that can be extremely useful and make operation much safer. Thanks for the info !
 

·
Registered
Joined
·
6 Posts
@Chris..... I know this is a terribly old thread but I'm new here and found your post saying you installed a train horn.
Can you provide any details about what you installed, how difficult/easy it was and where you purchased it?

I absolutely hate the horn on this Rebel. Press the horn and it does not immediately respond, drives me nuts.
 
1 - 8 of 8 Posts
Top